Futaba 18sz Butterfly function
#1
Thread Starter
Join Date: May 2010
Location: Blackpool, UNITED KINGDOM
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Futaba 18sz Butterfly function
I am setting up my 4 servo wing glider and come to the butterfly function, everything gone to plan except when I have dialed in elevator compensation. On my old 12 fg I could assign this compensation to a fine tune knob, am I correct in assuming that the 18sz does not have the function to fine tune the elevator in the butterfly function ??
My butterfly is set up on the LS slider switch
Thanks
My butterfly is set up on the LS slider switch
Thanks
#2
Thread Starter
Join Date: May 2010
Location: Blackpool, UNITED KINGDOM
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Just found out last night there has been a couple of software updates since I purchaesd my 18sz, one of them is for fine tuning on the elevator within butterfly
Now where did put that SD card !!!
Now where did put that SD card !!!