TopRc Voyager build
11-24-2020, 02:16 PM
#51
https://hobbyking.com/en_us/800mm-tw...-5pcs-bag.html most of them are from them with different length and 22 awg the price is right and I never have any problems with those
I highly recommend you swap to true 20awg wires to eleimnate possible issues.
Good luck and I hope you will not have issues.
11-24-2020, 03:18 PM
#52
11-25-2020, 01:31 PM
#54
My Feedback: (5)
Join Date: Apr 2002
Location: parlin,
NJ
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
voyager
This is a very nice plane iike it very much, it is the right size for some very nice jet flying. It looks good in the air.. You get something for your money. But I have one problem with toprc models .Is that you can't get the Voyager in a timely manner. If you go to there website you see the voyager in different color configurations. You should be able to buy this from the factory and they ship it it right out. They could also drop ship it from the factory. it would save a lot of time. I have brought many planes that where drop shipped from asia. By the time you get this plane the way you want 4 months have pass.Part of The season is gone .Also the price is going up as we wait. Just my thoughts
11-25-2020, 04:10 PM
#56
Two colors available for shipping USA only, the Mercedes and the Marine one , all the other colors are on the way to USA in a container, and this is the least expensive way for shipping, individual shipping off big box like this will cost half the cost of the jet.
11-30-2020, 05:52 AM
#58
Where did you did your cg ? This could help others with the same jet because the recommended one is totally wrong, nice flying, I only have a chance to fly 3 times because my turbine had a bad day the starter motor broke and now is way too cold to fly
11-30-2020, 06:09 AM
#59
The following users liked this post:
Fighting Falcon (09-15-2021)
The following users liked this post:
Fighting Falcon (09-15-2021)
12-07-2020, 06:58 AM
#64
2 things I recommend:
1: glass the servo plates for flaps - 2mm plywood is not enough and flexes a little
2: Washers were needed to shim the landing gear for them to be a perfect fit in the wheel wells
50 or so flights on mine now - loving it!
Yesterday I took off 10mm of skin from under the wings to get 33 degrees of aileron throw for a faster roll rate for some rifle rolls. (stock roll rate was too little for a sport jet IMHO)
Last edited by GULDUKAT; 12-07-2020 at 07:01 AM.
The following users liked this post:
Fighting Falcon (09-15-2021)
12-27-2020, 08:51 AM
#72
Join Date: Jan 2006
Location: Pierrefonds, QC, CANADA
Posts: 21
Received 0 Likes
on
0 Posts
The following users liked this post:
FLY200 (12-03-2023)
The following users liked this post:
jandavid59 (01-28-2021)