RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: LSP972
Showing results 1 to 8 of 8
Search took 0.12 seconds.
Forum: Kit Building
04-16-2006, 09:33 AM
Replies: 723
Views: 118,455
Posted By LSP972

RE: Goldberg Ultimate 10-300 build

My point exactly. My first Super Aeromaster, which is a bit smaller than the Goldberg Ultimate, had a YS 120N on the issue GP nylon mount, and was built in 1993. The fellow who bought it from me is...
Forum: Kit Building
04-15-2006, 04:00 AM
Replies: 723
Views: 118,455
Posted By LSP972

RE: Goldberg Ultimate 10-300 build

Uh.... what am I missing here????? Isn't the whole point of a soft mount to minimize vibration transfer to the air frame? So why stiffen it?

Personally, I question the actual need for a soft...
Forum: Kit Building
04-04-2006, 08:11 PM
Replies: 723
Views: 118,455
Posted By LSP972

RE: Goldberg Ultimate 10-300 build

Man; what a bummer. That was a beautiful model. This thread has caused me to break mine out of mothballs; I'll fly it this week-end. I'm also keeping an eye peeled for a kit. The Empire shows limited...
Forum: Kit Building
03-29-2006, 01:40 PM
Replies: 723
Views: 118,455
Posted By LSP972

RE: Goldberg Ultimate 10-300 build

My admittedly limited Saito experience (four; 150, 100,91,56, all NIB and broken-in on a test stand) has been that the motors come out of the box excessively rich on the low-speed needle. And that...
Forum: Kit Building
03-29-2006, 09:19 AM
Replies: 723
Views: 118,455
Posted By LSP972

RE: Goldberg Ultimate 10-300 build

Correct; and very important to remember. A dead-stick Ultimate, regardless of how much it weighs, has the gliding characteristics of a cinder block; all that parasitic drag, one assumes. Anyway, if...
Forum: Kit Building
03-27-2006, 08:18 PM
Replies: 723
Views: 118,455
Posted By LSP972

RE: Goldberg Ultimate 10-300 build

Here's a couple of shots of my ShowTime.

You CAN make a plastic spinner fit right if you take your time; and I think the solid red looks better than silver would...
Forum: Kit Building
03-27-2006, 08:13 PM
Replies: 723
Views: 118,455
Posted By LSP972

RE: Goldberg Ultimate 10-300 build

Well, I'm not sure just HOW you were getting whacked; unless you were turning the engine through priming/compression strokes with the glow heat attached?????

I fuel, prime, turn the prop up...
Forum: Kit Building
03-27-2006, 02:45 PM
Replies: 723
Views: 118,455
Posted By LSP972

RE: Goldberg Ultimate 10-300 build

Guys... I've been running plastic spinners on big four strokes for many years. The ONLY times I've had problems were due to...

1. Running the engine lean enough to make it backfire. That will...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.