RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: HiCurrent
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Forum: RC Warbirds and Warplanes
05-22-2020, 06:45 AM
Replies: 299
Views: 85,541
Posted By HiCurrent

One of my wing is heavier than the other but I...

One of my wing is heavier than the other but I have serious ailerons trim on that side to push it down more. so I just left it. if I fix the lateral balance, I would need more trim. It is flying...
Forum: RC Warbirds and Warplanes
01-11-2020, 03:04 PM
Replies: 299
Views: 85,541
Posted By HiCurrent

I already had 2 flights with it, but have not...

I already had 2 flights with it, but have not tried flaps. Tomorrow, I'm going to try the flaps. Thanks for the information.
Forum: RC Warbirds and Warplanes
01-10-2020, 08:03 PM
Replies: 299
Views: 85,541
Posted By HiCurrent

Thank you for the response. Does it pitch up or...

Thank you for the response. Does it pitch up or down. My full flaps currently setup at almost 40 degrees
Forum: RC Warbirds and Warplanes
01-10-2020, 12:58 PM
Replies: 299
Views: 85,541
Posted By HiCurrent

is there any pitch changes when flaps are down ?...

is there any pitch changes when flaps are down ? any elevator mixing required ?
Forum: RC Warbirds and Warplanes
01-06-2020, 02:11 PM
Replies: 299
Views: 85,541
Posted By HiCurrent

Mine looks like hard grade balsa sandwiched...

Mine looks like hard grade balsa sandwiched together. When I was putting the gears in, it got squeezed quite easily. I was afraid to tightened it up too much. Definitely not plywood. I knew it would...
Forum: RC Warbirds and Warplanes
01-06-2020, 12:50 PM
Replies: 299
Views: 85,541
Posted By HiCurrent

look closely at the grain, it is balsa, not ply....

look closely at the grain, it is balsa, not ply. Mine broken off with ease.
Forum: RC Warbirds and Warplanes
01-06-2020, 11:54 AM
Replies: 299
Views: 85,541
Posted By HiCurrent

does anyone realized that the landing gear plates...

does anyone realized that the landing gear plates are made out of balsa wood and not plywood. I realized this during the build but was hoping that it would be ok, then Murphy law kicked in. I ran off...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.