RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: luckymacy
Showing results 1 to 8 of 8
Search took 0.01 seconds.
Forum: RC Jets
10-19-2020, 08:53 AM
Replies: 692
Views: 295,196
Posted By luckymacy

try putting a couple of washers under the forward...

try putting a couple of washers under the forward set of turbine bolts to increase the exhaust downthust a tad more?
Forum: RC Jets
10-19-2020, 05:16 AM
Replies: 692
Views: 295,196
Posted By luckymacy

Do you think raising the front by a quarter or...

Do you think raising the front by a quarter or 5/8 inch would eliminate the additional throttle to elevator mix?

i will check the wings relative angle to stab when I get a chance. I’m curious now.
Forum: RC Jets
10-18-2020, 10:44 PM
Replies: 692
Views: 295,196
Posted By luckymacy

Curious if anyone has an issue with jet climbing...

Curious if anyone has an issue with jet climbing too easily with speed? I carry down trim even with the CG maybe just hair nose heavy. The turbine and exhaust tube are at whatever incidence the kit...
Forum: RC Jets
05-11-2020, 02:32 AM
Replies: 692
Views: 295,196
Posted By luckymacy

delete...

delete...
Forum: RC Jets
05-11-2020, 01:02 AM
Replies: 692
Views: 295,196
Posted By luckymacy

what specific fuel tank fittings are you using...

what specific fuel tank fittings are you using and where did you get them and what is that box on top of your tank?
Forum: RC Jets
05-10-2020, 05:43 AM
Replies: 692
Views: 295,196
Posted By luckymacy

does everyone else have a landing function to...

does everyone else have a landing function to activate the crow function? IF you do a go around with full flaps and crow already going on, how do you gracefully back out crow and full flaps? On...
Forum: RC Jets
05-04-2020, 11:41 AM
Replies: 692
Views: 295,196
Posted By luckymacy

What specific control surface related hardware...

What specific control surface related hardware such as push rods are folks replacing or is everything more than acceptable in the latest versions of the kit?
Forum: RC Jets
05-03-2020, 07:37 PM
Replies: 692
Views: 295,196
Posted By luckymacy

Would someone measure the struts and wheel...

Would someone measure the struts and wheel dimensions? Need it to know if a set I have will fit.

thanks!
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.