RCU Forums - Search Results

Search: Posts Made By: plasticjoe

Showing results 1 to 5 of 5
Search took 0.09 seconds.

Forum: Kit Building

11-14-2007, 10:51 PM

Replies: 723

Goldberg Ultimate 10-300 build

Views: 118,455

Posted By plasticjoe

RE: Goldberg Ultimate 10-300 build

Snoopy survived without a scratch... tonight I reset 2 ribs in the top and bottom wings... one end of each interplane struts snapped the tabs off... once that all sets up tonight... I'll fill all the...

Forum: Kit Building

11-14-2007, 07:34 AM

Replies: 723

Goldberg Ultimate 10-300 build

Views: 118,455

Posted By plasticjoe

RE: Goldberg Ultimate 10-300 build

I used the same setup on the repair and instead of a 1/4" plywood cross bar, it's now a stainless steel tube crossbar and loctite all over the place. The link from the crossbar to the servo is now a...

Forum: Kit Building

11-13-2007, 09:36 PM

Replies: 723

Goldberg Ultimate 10-300 build

Views: 118,455

Posted By plasticjoe

RE: Goldberg Ultimate 10-300 build

I have dual pushrods from the elevator halves going to a crosspiece that had a linkage from it to the servo... Here's my feeble attempt at a diagram LOL
The Sullivan brass linkage broke at the...

Forum: Kit Building

11-12-2007, 08:24 PM

Replies: 723

Goldberg Ultimate 10-300 build

Views: 118,455

Posted By plasticjoe

RE: Goldberg Ultimate 10-300 build

Was flying mine on saturday and had an elevator linkage break on takeoff.... it lifted off and then kinda hesitated about a foot off the ground. I thought it mighta been the engine sagging ? ... so...

Forum: Kit Building

08-31-2007, 07:14 PM

Replies: 723

Goldberg Ultimate 10-300 build

Views: 118,455

Posted By plasticjoe

RE: Goldberg Ultimate 10-300 build

I've been kicking around the ideal of a Zenoah G20ei in mine.... currently I have a saito .91 in it... it flies ok... but seems a little short on the power side. Is there enough room under the cowl...

Showing results 1 to 5 of 5