RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: horsefeetky
Showing results 1 to 25 of 32
Search took 0.01 seconds.
Forum: RC Jets
08-03-2019, 04:59 AM
Replies: 692
Views: 295,101
Posted By horsefeetky

Be sure to take brakes apart and clean all oils...

Be sure to take brakes apart and clean all oils from them I use denatured alcohol
Forum: RC Jets
07-28-2019, 10:57 AM
Replies: 692
Views: 295,101
Posted By horsefeetky

Predator wing bag fits perfectly also this...

Predator wing bag fits perfectly

also this planes spar tube i twice twice the wall thickness of a predator I would not worry about needing a carbon one
Forum: RC Jets
01-12-2019, 02:44 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

no grease you will regret it.. if you must you...

no grease you will regret it.. if you must you can use dry lube spray.. but i suggest taking the brake magnet side and hone it on a flat table with a sheet of 600 grit. clean it well and clean the...
Forum: RC Jets
01-12-2019, 06:37 AM
Replies: 692
Views: 295,101
Posted By horsefeetky

alfawaz did you get the same sensor spacing i...

alfawaz
did you get the same sensor spacing i have noted above... i would strive to get cg right by moving battery packs around until things work out. you may need to reduce the size of your packs...
Forum: RC Jets
01-11-2019, 02:07 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

i score the paint with an xacto knife first...

i score the paint with an xacto knife first thentry my best to cut with the dremel wheel just inside the line.. works well most of the time but going slow and using a cut off wheel grit wheel is...
Forum: RC Jets
12-16-2018, 04:38 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

just ran the swiwin 140b it is a beast.. all i...

just ran the swiwin 140b it is a beast.. all i could do to hold the fuse in the cradle during run up..

found a problem all need to check......................ALERT

loosen your elevator,rudder...
Forum: RC Jets
12-16-2018, 06:24 AM
Replies: 692
Views: 295,101
Posted By horsefeetky

i was surprised to find the predator weigh in at...

i was surprised to find the predator weigh in at 30 1/2 pounds with k180g in it.. the jet feels so much thicker in glass and overall i found it to give me the impression the ody would be much lighter...
Forum: RC Jets
12-15-2018, 06:13 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

got the full gyro settings done now just a run up...

got the full gyro settings done now just a run up of turbine tomorrow afternoon and im ready to placebatteries in sotrage mode for winter.. been doing dbl time as im setting up a predator with k180...
Forum: RC Jets
12-15-2018, 11:14 AM
Replies: 692
Views: 295,101
Posted By horsefeetky

just put mine on the bench again toady and...

just put mine on the bench again toady and leveled the wing to zero incidence and it did move my cg a tad forward it is now a solid 215mm from le

i am going with that for maiden and can move a...
Forum: RC Jets
12-14-2018, 05:19 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

also take note on my rtf dry weight im using a...

also take note on my rtf dry weight im using a swiwin 140b that is pretty light no pilot either. so im doing all i can to keep this jet light for everyday sport flying next year. i will dbl check all...
Forum: RC Jets
12-14-2018, 05:07 AM
Replies: 692
Views: 295,101
Posted By horsefeetky

and yes you can do the old school method of...

and yes you can do the old school method of balance. i suggest using two short blocks of 2x4 drilled in the center of the wider side to accept a wood dowel each with a small sticker of soft velcro on...
Forum: RC Jets
12-14-2018, 05:02 AM
Replies: 692
Views: 295,101
Posted By horsefeetky

cg

https://cimg2.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/640x480/ody_d155059964ace576478f41ec39bff68de62fa698.jpg

using digitec scales same as xicoy i think
Forum: RC Jets
12-12-2018, 04:47 AM
Replies: 692
Views: 295,101
Posted By horsefeetky

stock gear.. added 6 ounces in left wing to match...

stock gear.. added 6 ounces in left wing to match right one's weight, no smoke system and mine is the white sport scheme as the original one made.
i think some will have more weight due to paint...
Forum: RC Jets
12-11-2018, 03:12 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

29 1/4 pounds with uat full i used hvy 8 ply...

29 1/4 pounds with uat full

i used hvy 8 ply plywood for the nose plate to sti batteries on. hysoled it in place with velcro on top. placed my 3800 3s lipo turbine pack and my 2s 1300ma lipo brake...
Forum: RC Jets
12-10-2018, 05:10 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

i just glued a plate in the nose for my batteries...

i just glued a plate in the nose for my batteries to ride on.. im getting close to the balance but i put my uat in front of the fuel tanks. im sure it would have gone better if it were in front like...
Forum: RC Jets
11-15-2018, 02:39 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

stock gear seems good just make sure the lead for...

stock gear seems good just make sure the lead for the retracts or brakes you use does not share a red or blk lead with any servos in the harness...

pro links and behotec are very nice gear sets...
Forum: RC Jets
11-12-2018, 04:59 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

go up a few posts and view the pics of mine.....

go up a few posts and view the pics of mine.. same uat turned side ways as you are asking about.......
Forum: RC Jets
11-07-2018, 03:36 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

anyone know the totalfuel tank capacity when...

anyone know the totalfuel tank capacity when linking the two together.
Forum: RC Jets
11-05-2018, 04:23 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

i fly 3w be sure not to share any ...

i fly 3w

be sure not to share any connections on the same pins in your plug for wings. some guys share pos and neg on the servos to make the number of pins work out

i used a store bought...
Forum: RC Jets
11-04-2018, 06:06 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

now when i get a nice day i will run the new...

now when i get a nice day i will run the new swiwin 140b in it then i only need to setup the ar3000 gyro that right now is not plugged in for first flight... balance with the uat full came out right...
Forum: RC Jets
11-04-2018, 06:00 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

gewtting closer to finished

https://cimg6.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/640x480/ody1_347b9aa45115db355230753c2231d0a896ed487a.jpg...
Forum: RC Jets
10-29-2018, 05:32 AM
Replies: 692
Views: 295,101
Posted By horsefeetky

hysol is used to seal them

hysol is used to seal them
Forum: RC Jets
10-28-2018, 04:46 AM
Replies: 692
Views: 295,101
Posted By horsefeetky

no 3s on retract board.. i plugged in my turbine...

no 3s on retract board.. i plugged in my turbine battery during setup and smoked mine last night.. it also took out the motor to the right wing i had attached...more parts needed now.

lior

did...
Forum: RC Jets
08-05-2018, 01:49 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

plug and unplug the retract a few times from the...

plug and unplug the retract a few times from the power board. it may just have some corrosion setup. chad did not fly it but once and it was in his garage for a year.. the board senses amp drap when...
Forum: RC Jets
07-16-2018, 05:56 PM
Replies: 692
Views: 295,101
Posted By horsefeetky

looks like a kangaroo hop on landing did in the...

looks like a kangaroo hop on landing did in the tail

mine looks more than stout in the fuse sides to handle flying with a 140
Showing results 1 to 25 of 32
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.